I agree. I think I'm pretty understanding of the physics. I guess small scaling will be more accurate than larger scaling. I guess what I am...
Books about learning the ballpark?
Sorry if there is a thread already covering this a couldn't find it. Basically, I'm looking to do some reading about the scaling of designs....
Maybe you should lay off the fumes, and repurchase the books you through away. I have practical experience, however I choose to wear a respirator....
Incorporating a model for a hull with non-developable surfaces and multilayer stress-strain relations of both anisotropic and isotropic materials...
I don't believe they are opposites. In foam sandwich, the foam acts to keep the skins separated, giving the laminate its strength. In sheathed...
Glue or Resin? I put resin on a smooth surface [formica] to make smooth streets of material, that peel off easily. I'm not planning on using...
Imho Read the original referenced book. Page 13. I apologize. I was using "cold molding" as a general term. I thought consistent with the...
I couldn't find a topic that covered this extensively. I've read over most of the Gougeon Book and it only really touches on it briefly....
I don't think I'm explaining this well. In order for the strips to lay coincidental the veneer would have to be doing a very small about of...
The "little steps", are they coincident or tangential to the curvature that they are not bending in? (the curvature along the width of the strip)...
Four hours on an airplane today... I made it to chapter 12... great read. That would do it. Seems like a bit of work but would definitely...
Working on the reading now. I guess my last question would be what you mean by "shaping of the individual strips" I'm sure the reading will answer...
I understand this is how it can be done, and quite possibly would be the most efficient method. However I feel like CAD is such a powerful tool...
So I'm having some problems designing a hull in rhino. I would like to design the boat to be made cold-molded with plywood and veneer strips. The...
This is for a 40mph power boat. Solid 2" aquamet 22 is the recommendation of the calculations in Dave Gerr's "Boat Mechanical Systems Handbook" If...
I'm not sure I would consider this a debate. Debate would infer valid arguments on both sides. This in more of a lecture in my opinion.
I now also see SS 630 as an option
I am told that it is best not to use 316, because it has a very low yield strength despite a high ultimate strength. 329 shouldn't be much more...
2x6ft aquamet 22 2" 2x3ft aquamet 22 2.25"
