Are there any special sanders out there that can sand an inside curved surface? I am painting the interior of a marine shower with curved corners...
What is the best adhesive to use for attaching fiberglass to plastic found in Yamaha hulls? I know West System G-Flex works but is there something...
I want to paint ( roll and tip out ) a small boat with a good 2 part polyurethane, are the fumes dangerous? This will be done in an attached garage.
Typical hose with prime bulb has 2 connectors. One is obviously the fuel supply. Is the second one a fuel return line to the tank or a air vent?
I've wet sanded down to 1500 grit and used automotive polishing compound to gloss it up. Is there a better system to get a high gloss shine on...
is there away to predetermine the amount of layers of glass cloth needed to achive a certain thickness? Also strength added per layer? Also what...
The angle grinder creates a lot of static electricity while working on fiberglass. Should I be concerned ( fuel tank fumes ) about blowing this...
what's the best way to cut kevlar cloth, what about carbon fiber? Also do these materials wet out like regular fiberglass cloth, I'm using epoxy...
I need to remove the gel coat from a slightly curved hull area. Is it possible to rip it off with a router or some similar tool? The area is about...
So what Company offers the best value in small ( up to 14' ) inflatables, RIB or roll-up? Long lasting - durable - affordable - good service,...
With the high cost of fuel I am in the market for a smaller boat with less power. Might have to spend less time running and more time at anchore...
Does Yamaha or Honda make fuel injected ob's in the 50 to 100 hp range? Also, is there much difference in fuel economy between the 2 and 4...
Would like some idea as to what some of you earn from small boat building shops?
Is there anywhere to learn inflatable tube construction other than a manufacturer?
Redoing a transom ( 7' x 3' ) with a gelcoat finish. What is the best method to get it to a glass like finish. I have brushable gel in white. Can...
Can anyone provide a web address for a really good tube builder. Looking for tube sets 10' up 16'. Any US or Canadian location will do as...
Looking to do a repair to the aft side of a boat that has a hole punched in it. Damaged area about 3 feet long by 1.5 feet high. The area is not...
