Yes i see these iquana before
Did you sea this?
I have 15 deadrise at the transom, but i keep it till the past midle of the boat
You can sea i bend it up in the bow
It is also a plumb bow design
What you think about sea keeping vs my monohedron 15 degres
It is actauly a mold of the boat
This hull is warped botom deadrise stern 10 degres in the midle 15 degre
Actauly i bend it litle bit, i Will put a picture with stati waterline
and the hump is not pronounced
i see some submarinig but not broaching efect as i do very sudden ruder turn
it is only video, i made 20 minutes of testing, but i film only this. later litle water entered and the motor controler go in smoke....
i will try to figure out how to do better next test
What is the point you use to "push" the boat? Is the "arm" that pushes the boat stiff?
the point i push the boat i think i mathed the shaft...
Latest model made 1:20
Ok, i Will do more result from this latest test, i Will mesure the towing force. I only look sea keeping ability, as i can see looks good, and i...
Yes i Will do, Thank you all for your advice, i Will do first another towing probe with 1:20 model towing, slightly modified bow
towing froud number 1.25 = 25kts
than last 30secondo towing froud 1.7= 35kts
thank you very much