:D Sure would be glad to share. I have never built an operating version. I think some others have. I will dig out those files and pass them along.
All I can add is I would be happy to look at the file to see if I notice something.
“My question is this; because I am making small model boats can I use delftship (or any other suggested program) to design a boat that can be...
Sorry fixed the link.
The addition of notches for stringers and cut outs for beds, plus allowances the strongback is not automated. It can be time consuming to get...
You can loft the stations in 2D CAD, or draw a 3D model from the offsets. Once you have the stations in digital form they can be exported in .dxf...
:D Cliff has done the work for us and posted it on his site. A very good run down on exporting 2D Rhino to .dxf....
J, This question comes up a lot here in many forms. There is a huge amount of information down in the software section of this forum. Learning...
Maybe this will fit the bill. http://www.bateau.com/studyplans/TX18_study.htm?prod=TX18
Some of the Garvey designs would be easy enough to do plate development for. You would still have to do the scantlings and interior structure....
Thanks PCV for bringing this thread to the top. It is a good example of the vast amount of information this forum holds. PS, Craig, Good to see...
Here is an example of an unpainted glass, Kevlar, foam composite canoe. This combination gives you an ultra-light, strong hull with a great...
It is common to sandwich Kevlar between glass in a layup so you don’t sand into the Kevlar during fairing. I would overlap the seam at the...
Good stuff. Thank you Peter.
Maybe you like these. http://www.boatdesign.net/gallery/showphoto.php/photo/1382/ppuser/1404
This is a good contemporary look at the design spiral using CAD software. http://www.newavesys.com/spiral.htm There also is a long list of...
Choosing the right point? Zoom way in, or if you pick the wrong one and it is in the way, pick it and hide it. Some of the Pros that visit here...
I should sit down and write a tut for this just so I can remember it. I used 2000 or older version when exporting .dxf for CNC. If you open it in...
If you use the make 2D it will be on the c plane when you import into AC. (I think) If you use the curves you may have to rotate and project to c...
