NANOCORE by thge Farside Global group looks really promising. apparently its a corrugaed tube system inside composite skins using a proprietary...
Seeking advice on material for hydrofoil on hysucat (10 m x 3.6 m). Have used expensive stainless steel in the past. Considering carbon fiber and...
Would a 40 percent resin to 60 pct reinforcement ratio by weight be a reasonable real world target for a vac infused laminate?
Thinking in terms of a prius like hybrid system that would allow much running to be done off electric motors. In a fishing boat for example run at...
They have done some ferry boats in scandanavia w on shore recharging. Thinking a diesel generator for reccharging like an old u boat?
Has anyone done any work for electrical propusion with a recharging system for long range? Apart from Elon Musk.
seeking 50 k plus reserve capital. Have available Molds for 33. Ft stepped hull center console and iconic trademark. 26 cc ready to finish Plugs...
Have not done layup yet. Would prefer in mold gelcoat rather than post finishing part. Concerned w print through of biaxial cloth.
Have not laid up part yet.seeking advice on what surfacing veil or print blocker to use for best surface quality.
What would you recommend for surface coat and printblocker other than csm?
Seeking advice on a means to prevent print through. Gelcoat/ 2 csm layers vinylester hand layup followed bt 1708 vac infused epoxy. Is there an...
Email sent Ryborunneryacht@gmail.com
