Gonna switch to wood and cut some costs for this build.
Just wanted to post a link for future use.
CarbonFoam PE Foam - Carbon-Core Corporation...
Thank you I will.
Appreciate it everyone.
Ok thank you all for the help.
Thanks for the replies.
-Not prejudice against wood, just thought there was something I could use to bend/flex easier and lighter than wood and to...
Want to go as lite as I can and least wood possible.
I have several plans in stock and trying to decide which boat I want to build (16'-18' Flats/Bay Boat).
The plans call for plywood/plywood on...
Looking to build a Sailboat like the Goat Island Skiff (link below).
1. Looking for a open cockpit.
2. Looking for a 18' (if possible-two...
I have never seen this setup-Thanks.
I was thinking the same basically and using a tunnel to raise the prop/lower and in the up position the prop...
I'll have to see if I can find a link to check them out.
17' boat and 17hp air cooled motor and not sure of the shaft.
This will be a test boat for this configuration then use this setup in a bigger one....
Building a liftable propulsion system for small fishing craft. The BOB Drive - BOBP/MAG/14 http://www.fao.org/docrep/FIELD/006/AD531E/AD531E00.HTM
Yes agreed, but ,,, :)
Thank you, awesome design
Wow, Thank you!
Do any of you know of a boat design that used a shaft connection (inboard) to a drive shaft to prop, that could be raised and lowered as needed...
Ok thank you very much.
Been reading up on a lot of posts to learn.
Hello, soon (in a few months) I'll be building a Spira Albion 19' (first time builder).
Plans call for a 5/8" on the bottom of the hull and I was...