My name is Riccardo. I want to ask you an important question; what is the test procedure during Bollar pull on board PSV VESSEL?
I must find for my fishing boat the correct LOA (as per regulation CEE n.2930/86). in order to verify the international tonnage of...
My name is riccardo, I have received question regarding some procedure on board of ships . I don't understand what to do for Prepare...
I have a fishing vessel of 16 mt in lenght, I must install on board two fuel tanks. Must These tanks be made of steel or reinforced...
I have a boat used to transporting of people; i must put near the living room a room containing electrically heated cooking plate or...
I have a boat used to recovery oil; the lenght of the boat is 16 m; In this case I think that Load line convention is not applicable,...
I must insert in my boat some batteries; where do I put them? As per European Directive i should ensure appropriate...
What is a stand by of a pump?
is the automatic start? or is the stop of the pump in case of small flow?
HOW CAN I ESTABLISH THE EARTHING SYSTEM ON BOARD SHIP?
WHAT ARE THE REASONING TO DO?
many thanks in advance
My name is Riccardo, I'm a italian student; How can I determine the power and lateral thrust of the bow thruster?
how can I...
I'd like to find photo self-explanatory of some boats with details of hull and engine marked in the pictures ( techinical and marine...
I need following RINA RULES:
Rules for the classification of ships
with reinforced plastic, aluminium alloy or wooden hull (2008)...
I,m Ricard, a italian student;
for my project I have to settle on a supply vessel a crane, what must I do to limit the maximum...
I am an italian student; I don't understand because some small boats( pleasure boat) and fishing vessel are depowered;
I need to understand like I must to apply the Maritime Equipment Directive. I am an italian student.
if I don't find any marked...
What are the differences between oil water separator and oil filtering equipment? when should i use them?
i need to know this for my project(...
hi, i am a italian student, where i can find example of nesting(metal boat ) and example of cut sheet metal?
i am ricccardo, i am a italian student, i need drawings of boats in aluminium, where can i find it?
i using rhino, i want fairing the curves; my question is:
in every stations must i modify control point for remove curve reverse ?
i have a breakhorsepower of my boat; i want a medium diesel speed; how ì can to
choose this type of diesel? how i can to choose rpm?