What is the size of the hub ?
Try always to save your jod in .dxf mode 3d (Autocad 2007 level).
You will have more conversion options and a fair base to compare
I tried few times to open your file and failed.
Could you please tell me the software you built it ?
What do you mean by "3D file of the propeller?"
You have already the 3D file "OCN_3D.dxf."
Hello to everyone there .....
I suggest to follow the attachments.
If you need any help on construction details to the hub, please tell me....
Or maybe you need that for a Bow Thruster device ?
Hello everyone into your Group...!
Let's do the job by the book.
Please tell me more of your project's data to avoid any mistakes,
and give me...
Good Day to your Group...!
Send the size of Diameter and the Pitch.
First you should know the Ship's Flag and if they had surveyed the Main Engines' Installation when that happened (2008 or later).
You have to...
This Version 6.27.259 corresponds to last pro edition.
According to http://wiki.bk.tudelft.nl/toi-pedia/Rhino_File_Exchange
all the job...
I suppose that Delftship is the free version.
Could you please give me the version of it ?
Could you please tell me if you run a licensed copy of Delftship and/or Rhino ?
Where is your file ?
See the attached address
Is the only (engineering) safe manner...
Do you have any Limit on Propeller's Diameter according to your plans ?
Thanks for your comments/notes Gonzo,
So you give me a chance to provide details
This system is not work like that on the cases you...
There is no difficult point on that system.
1. The Engine runs stabilized at 1500rpm. The speed Governor is a 1724
A power plant concept near to your description had installed in several
vessels since 2002 and are still running properly on heavy duty....
The use of flexible pipe as intermediate is against to transmit vibration and stresses because of dimensional expansion as temp...
Have you checked the tighting torque to the cylinder's head screws ?
Many times on marinized vehicles' engines observed lower tension to...