Title says it all.
If the LAR keel is an appreciable percentage of the submerged hull area how should the L/W ratio be adjusted?
Does anyone have any design details on this?
rudder looks to be working dirty.
was watching this launch video of a Lightwave 38 and was struck by the height and thinness of the keel. See vid at 0:33 mark. This design would...
Is it recommended to place the chine under or over the WL?
There are always a few who take the Marchaj stability curves for catamarans and monos as being proof that catamarans are "inherently" more...
Trying to add daggerboards to the 34 foot catamaran design.
Can't put them on the inboard hull side as that is where the beds are.
Can't put them...
Thanks to Jorgepease
2017 Summer Update https://chriswhitedesigns.com/2017-summer-update
So one mast in each hull
1. all jib like his...
I hope you all survive Irma with everything intact.
May all your anchors hold.
walking on melamine rather than paint over FRP?
has anyone used melamine facing board, abt. 3mm thick, as a facing/structural material over...
how about 3 degrees high forward and 3 degrees down inboard.
Enough angle to clear leakage or more is needed? no angle is needed at all?
this is rough schematic of possible steering arrangement for light-displacement 10.5m catamaran.
the steering pulley is 12.7 cm diameter
can anyone suggest size and number of fenders for 35' sailing catamaran?
for a circular unstayed mast of 120 mm diameter would wrapping a halyard around the mast, say 6 turns in total from top to bottom, prevent the...
Gents, pushing electrons around the screen but need more practical advice.
For a bi-mast aft rig, each jib is 17.3 sq m with 5.7 m foot. Cat is...