please send pic's to firstname.lastname@example.org
i have a 1979 with a very bad repair job on the ballist keel to hull.
i mean finshing cloth and air bubbles the size of my foot.
so bad that i...
I've used west system for a mast repair with micro-fibers as my filler.
that same mast came back 3 years later. still holding strong(it came back...
If done a few old crist-crafts and i havefound that you start at the top and work down house windscreen rub-rails till you get to the deck most of...
corecell cost more but will never rot or delam. and to heavy
ply is cheaper and you will have to be sealed and will still give out some day.but...
can i see pic of them boat and molds?
I am not sure where you can read about it but I have used it for the sole (cockpit floor). in two boats with no problems.we resin coat the sheet...
I know i have a 197? cal25 mak2 i think
whats wrong with it ?
do you still have it?
what plastic are you talking about? starboard or other?
and if you are not likeing ply why not glassed over foam?
I like it. It is not for everyone. The bridge is too cool for a sail boat.(clipper ship)
I realy like the self furling sails(Anything that I...
I would use marine grade plywood.
and finsh any way you like.
I would fill you old screw holes
mask the new rail with tape..
dry fit the new rubrail drilling new holes as needed.
use heat gun for bends at...
what i have done is hot glue paint stick 1/8 off the hull the deck and bulge to form a templett of my new bulkhead . then set on my ply trace and...
I.m looking for some Kayak or long boat molds
email me @
does the mold come with the deck?
i have worked with rotocasting and would like to take to you about your mix.
like what resin or epoxy do you use and what fillers do you use...
how much for the binks set-up?
what i've done is make a plug out of mdf and 2lb foam sand and shape coat over with resin. skin with mat. and fair with poly-fairing compound then...