Additionally, my software will automatically offset sections based on the location of the initial zero point.
On a mono hull, Ive always used the point were the bottoms, and transom come together at the stern, the lowest, most aft part of the hull. Cats I...
export as dxf. import dxf
another vote for Orca
I am confident one of our 24'-26' shallow draft aluminum cats would satisfy your offloading and outfitting requirements. Every boat on our shop...
Our company is interested in the idea of a boat "rotisserie". Anyone have any experience in constructing such a thing? We may be doing a...
Does the curve look as what might be expected? Hull is a 30'x 10' "Cat". What determinations can be made from the output? All comments welcome....
Much thanks on the speedie and detailed response! Hull has been modeled, CG located. I will post some results asap.
hello! I having trouble understanding the the righting arm curve graph output by Rhinomarine 4. Am I tasked with determining how far a...
We are looking for drafting/design help. http://munsonboats.com Local hire only. Autocad a must. contact: Jesse Munson (360) 707-2752
Some good stuff there for sure! I need to nest aluminum parts, I wonder if these wood based programs will allow me to get around that...will...
Anyone have information on a free (or cheap) nesting program? Thanks!
Hello! I am in need of a way to extrude a line that has been imbedded into a surface, perpendicular to said surface, throughout the line length. I...
http://www.munsonboats.com
Thanks for the comments, weve used "flaps", with some success in the past, but as this boat will be run in Alaska, freezing may become an issue....
Im looking for comments on how to adequately shield 3"x10" open scuppers from green water penetration, Im thinking of a cast alum. bilster of some...
