Been busy on other things. Got it painted, floor all done front seats in, finishing off fuel tank covers/back seats.
Going to do some rustoleum type paint inside boat from floor up to under the gunnel sides. Bought carpet for floor. Going to lay down some mat and...
Its a 19' boat and thinking from the top 1/2 from the bumper rail up up inside and out, front bow and splashwell. . Area total guessing 300 sq ft....
I would really like to do a gelcoat paint job like this picture. Use a off white base and add the grey, light brown, dark brown splotches and then...
10-4 on the paint outside below the gunnels.
One more ondarvr there is something to be said for me to blow gelcoat on the entire boat inside, outside gunnels up, although I’m thinking on 2/3...
That’s good saves a step with no primer. Appreciate your help Ondarvr as always.
So the 120 is good to go? I hadn’t really decided on Primer was thinking prekote. Then I’m told sand 200 grit. Then the two coats of my base...
Still plugging along been pretty lazy. Have sanded the entire boat gunnel up with 120 next up 200. Going to carpet the floor. Then think a camo...
Got things cut to shape ready for some mud. A little trim and fill on the bottom corners, and some peanut butter tomorrow and I should have it...
Sides and bottom joints peanut buttered. Today get front cut to size and glassed in.
Should be sticking this splash well together today and then get it all fiber glassed then installed. Then put the wood dowel around the top and...
Going with a 1” dowel with a 1/2” deep slot in it stuck on top of the splashwell edges and vertical corners, then fibre glassed on when I...
Basically have a design for my splashwell made out of 3/8 inch plywood which would leave a narrow edge and sharp corners for bonking ones head on...
Motor mounted so I can size up and make the motor/splashwell. Looks good have the 5” extension kit for it. Decided to use old seats that were at...
Thanks Ondarvr. I wasn’t to sure guess I will throw a layer of 1708 and glass on it first.
Been busy with other stuff but have been chipping away at the boat. Stringers and transom/motorwell supports all encapsulated. Floor peanut...
Got my two outside stringers glassed in and encapsulated doing the middle stringer today then most of floor can go back on. Leave back ft open til...
The guy I bought the boat off had let it go. 1/3 of the floor still has some very old vinyl mat on it. The other 2/3rds of which I removed 1/2 of...
They are painting vehicles with it. I’m open to suggestions carpet is easy, done it before and with 1/3 of the floor with some vinyl crap on it,...
