A couple of rattles chucked out the prams there.
I thought surely someone could see the sarcasm in a thread entitled " arc strikes" giving the on going debate and input from yourselves on this...
Congrats Ad Hoc , looks like that sense of humour removal operation was a complete success.
Of course its a woman , surely you recognise traditional Australian bridal wear .
Just wondering what you guys opinions are of them . Are they a major defect ? , how can they affect the parent metal ? , is their a repair procedure ?
The hens will **** themselves on launch day.
Waikikin will be proud of ya .
Bearing in mind the original starter of this thread was going to use either cement or wood i think basic QA might not apply in this case . Unless...
Personally i wouldnt dye pen if it was new construction , however if it was a repair maybe due to a fracture then by all means feel free to dye...
Whats the repair procedure for a (stray) arc strike ?
Quite right Mikejohns , ok clean your weld area back to bare steel , underneath as well. Grind into either ends of the original weld to make sure...
You can lead a horse to water but a pencil must be lead .
Brent id hate to see the condition of the confined spaces after you,ve been in . There must be arc strikes all over the place . Maybe i was a bit...
Ha Ha typical Aussie just cos were kicking ya butt in the cricket .
Last clue , its to do with the anchor .
Why would the flux fall off !
Actually Shug it tends to be the bigger the boat the bigger the spur latch. Now that must be a clue .
Brent ya miles of the mark mate. A proven time served welder does not get a "sticky" rod .
This is how you avoid arc strikes , say for...
Im afraid everyone is a bit of the mark with there welding advice .
Im guessing you dont own a boat then Shug .