As inclining experiment has gotten necessary for existing ships in my country by the administrator, we have tested many methods depends on their...
Hi dear friends
If you want to do inclining experument for a 40x11 m catamaran passenger ship, what material do you use as inclining weights?
I guess increasing the breadth by two wing shape , is dangerous for other ships which pass or berth beside.
is it allowed to add two wings to the both sides?
Can we increase an existing ship's breadth ?
If not, which rule prohibit it.
if water can pass through those fittings then smoke also can leak into the engine room.but we don't have smoke leakage in the engine room.
What about "Exhaust gas pipes openning" shall i consider them as downflooding point?If water goes inside exhaust gas pipes, then water would stop...
In all loading conditions the same criteria has been applied.
This is the criteria that the designer considered for pipe-lay barge.
100A5 PONTOON EQUIPED FOR PIPE LAYING OPERATION ACCORDING TO OPERATION MANUAL
Is GL acting on behalf of the Flag...
In my case, I'm wondering why "GL" used criteria of MODU (Mobile offshore drilling unit) for the related pipe laying barge.
What stability criteria should be used to analyse stability for a pipe-laying barge?
The attached picture shows type of related...
When you want to calculate stability by MAXSURF, there are two options
for fluids in tanks: 1-maximum free surface 2-sumulate...
the barge is going to carry diesel oil .
which part of IMO i should check?
Is it necessary for an oil barge to have double hull?
Would you please help me with any information about semi submersible propellers for high speed crafts.
Any article or advise about...
you are right. this vessel was already a hydrofoil. after cutting 2.7M under water part , the vessel's shape changed to this new GA.
please see the GA. of the vessel in the attachment.It's light weight is around 185ton.
total test weight should be at least 11ton.
I used 200lit drum already for a similar boat but the width of new boat is 11.5m and i need 50 drums for 1degree inclination and...
what kind of test weight normally use for inclining experiment of a catamaran boat like the attached picture?