*Polyurethane contains isocyanate Although the two chemical names are similar, NO cyanide is used to make or is present in isocyanate products....
You can spay roll on poly if you thin it. Water can kill you and your paint job.
You right. I'll stick with the unprofessional products I guess.
That is a standard response I get and I find it kind of frustrating. Not your suggestion, but because of the way the auto paint industry is. I...
I'm looking to buy some 2-part polyurethane. I can tint it myself. Not looking for a lot, maybe a quart of white and a quart of tintable clear....
Guys will tell you that they can spray and it doesn't need to be touched afterwards. I've never seen it without a little bit of orange peel that...
Depends on how it is thinned. Duratec clear is 100% solids. No more porosity in the final product. Using a gelcoat gun will also require less...
I was trying to figure out what fabric was behind each print through, pretty hard to tell. I guess what started my thinking was I have seen print...
Thanks. I found a different one.
Does anyone have any good pictures of print-through? I feel like most builders have gotten good enough that you rarely see this anymore. The last...
In agreement. One addition, still tacky will be a primary bond, and sanded will be a secondary bond.
I see the problem much simpler than others, so maybe I'm missing something. Oxidation is on the surface. Wet sand, compound, buff, wax, whatever...
A single layer of 9oz biaxial would have three times the amount of fibers crossing your strip joints over the 60z and because it is stitched...
I'm not sold on the CF myself, but if you are doing it for the look I understand. Just remember CF is black and epoxy softens when it gets hot....
Personally, I think three layers of 3-4mm veneers would be ideal. The problem being where to find them. In an ideal world, these would be cheaper...
Why not plank the whole hull all at once? Also, I noticed you did 0/90 for the two layers. Typically, I see 0 (strip-planked) or +/-45...
