Been busy all spring working on my boat..It's coming along
Fixed some loose planking, stripped all the topsides..still considerable sanding to do but I can see an end..way down the road..but it's there...
Have two questions, I have a small gouge taken out of a plank in a hard to see area, Don't want to replace the plank for it and it won't show much, but wondering what is the best filler to use for that?
The other is back to the hull, scrapped all the loose stuff and need to pull out some old sikoflex, I want to putty some areas however not saure what produce is better? any thoughts..
Oh btw started the engine last week, ran like a charm..but no other electrical was working...there's a task!
cheers
Bill
Quote:
Originally Posted by PAR  Generally, it's not necessary to remove all the paint or coatings, just the damaged stuff at the surface. If it's stuck good and requires considerable effort to remove, you're wasting your time, just feather out the edges, putty were necessary and paint again. |
06-23-2009, 11:53 AM
Similar Threads 
Linear Mode
