 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
02-16-2009, 08:42 AM
| |||
| |||
| volvo 8.2 DP-SM gimbal bearing I have a 8.2 Volvo DP-SM, the gimbal bearing went bad. it is a convex shaped outer race that I see no way to install. I cut a slot in it to remove it or it would not have come out. There are no circlips, it only goes in from the rear. It has 2 small notches in the housing that looks like you could slip it in and then turn it? Maybe? Any help, suggestions?  |
|
#2
03-16-2009, 08:22 PM
| ||||
| ||||
| Seems like you cut the bearing in two and removed only the inner gimballed part. The outer ring comes out. It is press-fit. You need to either use a bearing puller or if the engine is out, hammer it out.
__________________ Gonzo |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cutlass bearing first or last? | pasty63 | Inboards | 1 | 02-13-2009 05:15 PM |
| Rudder Bearing | Wynand N | Materials | 5 | 01-30-2005 03:29 PM |
| Rope cutters / bearing protectors | h4marine | Press Releases | 0 | 03-24-2004 05:51 PM |
| Trailer bearing schematic | Spearfisher_Man | Powerboats | 7 | 08-07-2003 04:13 PM |
| Rudder bearing service | kudu | Boat Design | 2 | 06-27-2003 12:14 PM |
Linear Mode
