 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
06-14-2006, 05:44 PM
| |||
| |||
| How to thoaout MecChuriser I bought this 1977 Astro Craft with a 140 hp 4cycler it turn over last fall but now it woun't move ! How should I go about trying to start her? I was thinking about taking all the plugs out and putting some gas and oil mix in the cyclers and let it set a day or two and then try a rench on it but were ? Any I dears ???   |
|
#2
06-23-2006, 01:02 PM
| |||
| |||
| Does the starter ingauge? I fired mine up yesterday after a similar time period and I had to remove the starter, lube it up, and manually free the little pinion gear because it had rusted and froze to shaft. Additionally, I put a wrench on the main pulley and rotated it by hand a couple times first. Still nothing...even with at 75amp charger/started attached...Then I replaced the battery...and finally...vavroomm....now I'm just trying to figure out why its so sluggish after the wait... |
|
#3
06-23-2006, 01:29 PM
| |||
| |||
| Thanks for your help,But ! well the statrers OK the motor won't turn buy hand . I don't know were to salfey put a rench on the fround of the motor? the frount of the crank is covered with the frount mount to the deck,were elce can I put it ?? Tom |
Linear Mode
