Boat Design Forums  |  Boat Design Directory  |  Boat Design Gallery  |  Boat Design Book Store  |  Thanks to Our Site Sponsors

Go Back   Boat Design Forums > Design > Propulsion > Sterndrives
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Search this Thread Display Modes
  #1  
Old 05-24-2006, 10:49 PM
jakebaird60 jakebaird60 is offline
 
Join Date: May 2006
Rep: 10 Posts: 4
Location: ft campbell
cant get engine to stop running on???

have a 3.0 L mercruiser and have checked for stray votage in elec system and have adjusted timing and increased octane in fuel, engine will not sut off with key or switch periodically, it wants to keep running on and vibrates the whole boat and shakes erratically,
please help

jake
Reply With Quote
  #2  
Old 05-25-2006, 02:49 PM
stonebreaker stonebreaker is offline
Senior Member
 
Join Date: May 2006
Rep: 42 Posts: 437
Location: Shiloh, IL
That's called 'dieseling'. Usually caused by deposits in the cylinders or sometimes a bad thermostat. This link describes the problem, and also has links to more detailed sites.

Hope this helps.
__________________
Stonebreaker
Ph.D in Redneck Engineering - Piling it higher and Deeper.
Reply With Quote
  #3  
Old 05-26-2006, 10:44 AM
jakebaird60 jakebaird60 is offline
 
Join Date: May 2006
Rep: 10 Posts: 4
Location: ft campbell
thanks for the links, i will try to cange the plugs and see if that combined witg cleaning the carb helps. I dont thin my boat has a radiator, but i will check the thermo also, thanks again
jake
Reply With Quote
  #4  
Old 05-26-2006, 06:16 PM
stonebreaker stonebreaker is offline
Senior Member
 
Join Date: May 2006
Rep: 42 Posts: 437
Location: Shiloh, IL
Sometimes it's as simple as pouring some injector/carb cleaner in the gas tank, too.
__________________
Stonebreaker
Ph.D in Redneck Engineering - Piling it higher and Deeper.
Reply With Quote
  #5  
Old 05-26-2006, 08:23 PM
jakebaird60 jakebaird60 is offline
 
Join Date: May 2006
Rep: 10 Posts: 4
Location: ft campbell
hey thanks again for the tip, i already used two bottles of that stuff and increased the octane in my fuel, no luck though, i cleaned the plugs and points and i tried to get it time as per instructions in the seloc manual, but it runs even worse now, the timing doesnt advance when i remove the jumper from the dist, all the checks say the distributer is o.k, but the boat runs like crap now. I am gonna try new plugs and wires tomorrow, and any other advice would be greatly appreciated, do you think it could have anything to do with the fuel to air mixture??? and if so, how do i know when its correct???

thanks man, appreciate the help

jake
Reply With Quote
  #6  
Old 05-26-2006, 10:07 PM
tom kane's Avatar
tom kane tom kane is offline
Senior Member
 
Join Date: Nov 2003
Rep: 99 Posts: 728
Location: Hamilton.New Zealand.
Running on can be caused by an over rich fuel mixture at idle stage.
__________________
tomkane
Reply With Quote
  #7  
Old 05-27-2006, 11:13 AM
jakebaird60 jakebaird60 is offline
 
Join Date: May 2006
Rep: 10 Posts: 4
Location: ft campbell
o.k. will try to adjust that, not having much luck with the carb adjustments, but will attempt another try, thanks for the advice
jake
Reply With Quote
Reply



Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes


Similar Threads
Thread Thread Starter Forum Replies Last Post
need help getting submerged engine running REDSOXS1 Sterndrives 5 06-22-2006 02:31 AM
Stop water coming through hdragon Boat Design 3 03-04-2006 03:18 AM
Running rigging? trimarandan Sailboats 4 11-19-2005 05:48 PM
Tell me to stop.... Sean Herron Sailboats 2 10-22-2004 11:46 PM
It is good to stop of heel? Ivanmdq Sailboats 1 05-05-2002 04:19 AM


All times are GMT -5. The time now is 10:56 AM.


Powered by: vBulletin 3 Copyright ©2000 - 2010, Jelsoft Enterprises Ltd.
Web Site Design and Content Copyright ©1999 - 2010 Boat Design Net