finishing

lalusiva · #1 07-20-2007, 06:34 AM

hello.
i ve a problem with finishing of my FRP component.after primerapplication again for topcoat i vw to sand the surface with240 grit paper. but at edges the primer is reoved completly and again i ve to go 4 touch up..can any one give solution

i am doing PU finish over my component

SamSam · #2 07-20-2007, 10:25 AM

lalusiva, You should move this question to the "Boatbuilding" thread under "Fiberglass and composite boatbuilding".

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
finishing material	vishnubaiju	Fiberglass and Composite Boat Building	3	03-23-2007 03:23 AM
Aluminium; finishing touch	winters	Boatbuilding	2	09-14-2006 09:00 PM
finishing cast iron	tranmkp	Materials	2	02-09-2005 06:03 AM
metal finishing	paul roberts	Materials	0	08-30-2004 10:06 PM
Bottom Finishing	Corpus Skipper	Wooden Boat Building and Restoration	0	08-25-2004 10:02 PM