 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
04-15-2009, 05:25 PM
| |||
| |||
| question about Velvet drive transmissions Looking at 71-b to 71-c. What is the difference? Also, I see on ebay, some velvet drives have a longer snout. Is that extra part what makes them not a 1 to 1 drive. And if you had a longer snout velvet drive can you take that part off and make it a 1 to 1 drive. One last question. Is it easy to change it from a LH to RH? I see that the plate has both RH- LH stamped on it one on top and the other on bottom. I am wondering if unbolting the plate and turning it 180 degrees reverses it direction? Thanks guys. Mark  |
|
#2
04-15-2009, 08:35 PM
| |||
| |||
| |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Velvet Drive Problems | Jango | Inboards | 3 | 11-02-2007 08:00 AM |
| Velvet Drive | DOGGYDOO | Inboards | 4 | 05-28-2006 10:28 AM |
| Velvet Drive | DOGGYDOO | Propulsion | 4 | 01-07-2006 05:18 PM |
| Velvet Drive Question | DOGGYDOO | DIY Marinizing | 13 | 11-10-2005 11:30 PM |
| Velvet-Drive 71 (10-17) | gonzo | Propulsion | 8 | 06-04-2005 07:08 PM |
Linear Mode
