 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
04-03-2006, 02:52 AM
| |||
| |||
| Mating a ZF/Hurth transmisson to a Jetski motor? Has anybody ever tried to mate a transmission to a jetski motor for an inboard application? There are tons of old gentleman runabout plans out there but todays engines are just too heavy. Any thoughts?   |
|
#2
04-05-2006, 04:40 PM
| |||
| |||
| Not familar with your specific motor/trans combo, but, you could probably build your own "bell housing". After mounting a Flex plate with female spline to your Flywheel, mount a 1/4 - 3/8 thk alum plate to the engine (with large clearance hole for damper) Using Alum spacers mount the transmission to the plate, with transmission shaft engaging flexplate. Hope this helps ----- Jango |
|
#3
04-05-2006, 07:39 PM
| |||
| |||
| Thank you very much |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Hurth transmission | Psuedomonas | Marketplace | 0 | 08-24-2005 01:48 PM |
| help me ID this motor | don954 | Boatbuilding | 2 | 02-25-2005 05:13 PM |
| Hurth V-Drives | SeaBuzz | Powerboats | 17 | 01-05-2005 01:06 PM |
| Hurth V-Drives 4sale | drs3317 | Marketplace | 0 | 11-30-2004 11:13 AM |
| Hurth Transmission Noises? | E4ODnut | Propulsion | 4 | 11-29-2004 07:57 PM |
Linear Mode
