Propulsion - Page 12 - Boat Design Forums

		Boat Design Forums > Design
Propulsion

Sub-Forums : Propulsion

Search this Forum

Forum

Last Post

Threads

Posts

Props (1 Viewing)

Propeller selection, performance comparison, prediction, experience, and modification.

How to remove prop from MicroCat pedal drive

by tinhorn

02-12-2012 07:53 PM

220

2,433

Surface Drives (2 Viewing)

Surface Drives. Arneson, BPM, Seafury, PSI, Levi, Etc.

diy surface drive?

by Grumpyrelick

02-12-2012 10:45 AM

120

1,674

Jet Drives (4 Viewing)

Jet Drives (pumps, impellers, etc.)

Has anyone tried a variable grid plate

by jorgepease

Yesterday 11:01 AM

305

2,636

Outboards (8 Viewing)

2-stroke and 4-stroke outboard motors.

Electric outboard

by tunnels

Today 08:35 PM

588

4,617

Sterndrives (2 Viewing)

Stern drive lower and upper units, transom and gimbal assemblies, steering, and trim pumps. Mercruiser (Alpha One, Alpha One Generation II, Alpha SS, Bravo One, Bravo Two, Bravo Three, Bravo XR Sportmaster, TRS, Speed Master), IMCO, ILMOR, Konrad, OMC, Volvo Penta

Sub-Forums:

Gas Engines (link),

Diesel Engines (link)

Junk inboard/outboard repower with outboard?

by pistnbroke

02-02-2012 03:13 AM

426

2,739

Pod Drives

Volvo IPS, ZF, CMD Zeus, and other pod-drive systems

Sub-Forums:

Diesel Engines (link),

Gas Engines (link)

simple, robust pod?

by baeckmo

02-03-2012 08:13 AM

131

Inboards (5 Viewing)

Inboard and Vee-drive hardware: struts, stuffing boxes, transmissions, coolers

Sub-Forums:

Gas Engines (link),

Diesel Engines (link)

effect of close clearance tunnels on gear...

by johneck

Today 11:42 AM

369

3,079

Diesel Engines (3 Viewing)

Diesel Engines

Yanmar and westerbeke transmission

by kenJ

Today 07:30 AM

404

4,884

Gas Engines (2 Viewing)

Gasoline Engines

Switching 3.0l distributor

by CDK

01-19-2012 10:16 AM

254

2,504

Hybrid (1 Viewing)

Hybrid propulsion such as diesel electric, hydraulic.

Hydraulic Motor In Water

by Wolfhart

02-10-2012 10:42 AM

160

4,198

DIY Marinizing (5 Viewing)

A forum to discuss "do it yourself" marinizing of engines / conversion of automotive engines to marine use.

Weed eater engine conversion

by docott

02-10-2012 06:33 PM

214

4,105

Page 12 of 19

« First

Threads in Forum : Propulsion

Forum Tools

Search this Forum

Rating Thread / Thread Starter	Last Post	Replies	Views
overheats at idle capslovak	04-24-2006 03:45 PM by capslovak	0	1,455
Omc To Mercruiser Conversion sswhite	04-24-2006 10:58 AM by sswhite	0	1,872
Twin diesel / generator / single shaft prop setup SeaSpark	04-22-2006 03:47 PM by SeaSpark	2	2,027
radio controlled model : Need help in setting up the motors hdragon	04-14-2006 03:11 PM by yipster	5	1,352
Most efficient form of propulsion jmac	04-13-2006 11:08 PM by Steve H	13	2,530
Motor for Jetdrive vs. Prop Ky181	04-13-2006 10:02 PM by Ky181	2	1,279
New Engine Development brian eiland	04-13-2006 01:08 PM by brian eiland	2	1,507
Problems Yamaha 250 salt water II, stator/C.D.I. bmtsa2003	04-12-2006 06:52 PM by bmtsa2003	2	3,527
Poll: Favorite Type of Power for a Powerboat ( 1 2 3) mackid068	04-11-2006 12:15 PM by Ike	37	6,986
older mercury parts gage90	04-07-2006 03:04 AM by gerard baladi	2	1,414
Why does an I/O engine needs to operate at 140-160F Pevito2	04-05-2006 11:12 PM by blowhole	3	1,622
Mating a ZF/Hurth transmisson to a Jetski motor? SplineWeights	04-05-2006 07:39 PM by SplineWeights	2	1,429
I Need Power Steering Help!!!!! stoliti	04-02-2006 12:28 PM by marshmat	1	1,570
Volvo engine problems cnoel1	03-29-2006 03:21 AM by cnoel1	5	1,950
Swapping 4.3L to V8 brainsboy	03-27-2006 01:46 PM by gonzo	8	1,808
Problem with diesel "kill" switch! broadsword	03-16-2006 09:01 AM by broadsword	3	2,161
Calculating boat speed Nordy	03-15-2006 03:31 PM by jehardiman	6	4,189
Innovations in Waterjet Technology camglasgow	03-08-2006 10:43 AM by brian eiland	3	1,882
Gas turbine power for cabin cruiser camglasgow	03-07-2006 04:03 PM by Guillermo	5	4,191
Help - basic propeller lastboltnut	03-02-2006 05:22 AM by MikeJohns	1	1,084
Diference between 60º and 90º motor riveramunizaga	02-26-2006 09:03 AM by Jango	1	1,404
help with 69 johnson again revshot	02-25-2006 05:14 PM by gonzo	3	1,545
Retrofit turbine engine to powerboat. ( 1 2) Verytricky	02-24-2006 02:54 PM by brian eiland	21	4,591
1:78 ratio vs. 1.47:1 ratio ... which to choose? ( 1 2) ezfriday	02-18-2006 09:21 PM by gonzo	18	2,994
1985 Mercury 18XD carb swap? rvBilly	02-17-2006 02:38 AM by rvBilly	0	2,181
jet conversion sambo	02-14-2006 07:22 PM by sambo	0	3,005
Outboard Mounting Height When Using Bracket?? Capt. Chris	02-14-2006 08:08 AM by antonfourie	2	3,983
MSD ignition to replace blown CD box? revshot	02-14-2006 01:36 AM by revshot	3	1,256
oil mix for johnson hydro electric V115? revshot	02-10-2006 02:29 PM by revshot	0	1,383
Pulsing for Power in boats. tom kane	02-06-2006 08:26 PM by tom kane	11	4,441
Get Home Power JohnTReed	02-01-2006 04:32 PM by JohnTReed	3	1,931
Outboard Hight quesnel	01-26-2006 06:25 PM by quesnel	10	2,421
changing from outdrive to prop shaft rich99uk	01-26-2006 12:01 AM by kapnD	7	1,737
nothched or pocket hulls and motor height oissa67	01-25-2006 07:38 PM by RTek	2	1,376
aftermarket outdrives ldmalpha1	01-25-2006 06:48 PM by glassman	1	1,549
L on 25" transom RTek	01-24-2006 12:19 PM by RTek	0	1,342
Converting a jet to an outboard SCC-FI	01-24-2006 07:39 AM by SCC-FI	0	1,648
Stalling Problem MilitaryPopo	01-23-2006 01:26 PM by nevadamike	6	2,001
1975 Mercury 140 hp inboard drain plugs? whalepass	01-22-2006 02:28 PM by whalepass	0	1,411
engine bolt tightening specs MilitaryPopo	01-20-2006 01:43 PM by nevadamike	5	1,486

Mark This Forum Read

Page 12 of 19

« First

Forum Tools	Search this Forum
Mark This Forum Read View Parent Forum	Search this Forum : Advanced Search

	New posts		Hot thread with new posts
	No new posts		Hot thread with no new posts
	Thread is closed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT -5. The time now is 11:55 PM.