 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
06-22-2006, 07:13 AM
| |||
| |||
| OMC Cobra I have a 23 ft boat with an 89 Cobra outdrive. While the boat was backed in the water at the launch ramp, some water leaked out of the shift cable but when the boat was slid off the trailer it stopped leaking. Do I have cause for concern or was it because the cable was below the water line while still on the trailer? Any help would much appreciated. Don V  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't remove OMC cobra drive's HELP!!! | burt2 | Sterndrives | 2 | 07-16-2006 11:34 PM |
| Omc Cobra tools | jokey1 | Powerboats | 0 | 05-17-2006 12:11 AM |
| Swap 302 omc for 351windsor omc king cobra outdrive | allen | Powerboats | 6 | 04-11-2006 12:10 PM |
| OMC Cobra to Mercruiser Conversion | mcattac | DIY Marinizing | 4 | 07-18-2005 04:35 PM |
| does anyone remember/have an old cobra boat? | pud | Powerboats | 1 | 05-31-2004 05:25 AM |
Linear Mode
