 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
08-06-2005, 05:03 PM
| |||
| |||
| I/O Trim Problem, please help. I have a 1969 Sportcraft 21 footer. The trim on the motor goes up fine and the 1st down cycle fine. The next time I go all the way up and back down it stops an inch short. The next cycle 2 inches short, then finally it gets to where it only goes all the way up to half way down. Now if my dad stands on the outdrive it works fine. This is when it's on land, haven't tried it in the water... Any idea what's wrong?  |
|
#3
08-08-2005, 12:32 PM
| |||
| |||
| Mercrusier Pre-Alpha (R or 1) The boat is a 1968 Sportcraft C-Eagle and the Cylinders have the two lines at the front of the cylinders, not front and back... |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Performance/Handling Problem | Boa | Powerboats | 11 | 08-10-2006 07:36 PM |
| Volvo Penta power trim question? | Lil aj | Powerboats | 2 | 07-17-2005 03:09 PM |
| trim tab modification | manunk | Boat Design | 1 | 06-21-2005 09:06 PM |
| trim problem with boat I just bought, please help | jetchris | Powerboats | 6 | 06-03-2005 01:46 AM |
| Sea trials-one major problem | Powerboats | 6 | 05-10-2004 01:35 PM | |
Linear Mode
