 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
12-31-2004, 07:34 PM
| |||
| |||
| Crusader Repowering I just purchased two 8.1 HO MPI Crusader engines with Hurth trans which will replace Crusader 502s with BW V trans on a 1990 Silverton 40 Express. Would appreciate any advice, suggestions, recommendations, etc. regarding the change over, i.e., what else will I have to change, what I should consider changing and of course, any first hand knowledge of the engines. Wm. Love  |
|
#2
12-31-2004, 09:34 PM
| ||||
| ||||
| They are direct replacements. The 8.1 are lighter and a bit smaller. If your transmission ratio is the same, the pitch in the propellers will need to increase. The new engines have more HP and torque.
__________________ Gonzo |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Repowering a 1977 Angler V-24 | jpgoodnu | Propulsion | 3 | 08-11-2005 03:32 AM |
| Crusader 8.1 Enginge Oil Requirement | LADYLOVE | Propulsion | 1 | 07-22-2005 11:07 PM |
| Repowering | Corpus Skipper | Powerboats | 22 | 07-05-2005 05:43 PM |
| Repowering '85 Bertram 30 | tanqueray | Propulsion | 2 | 02-27-2005 11:05 AM |
| Repowering | capttwb | Propulsion | 2 | 02-22-2005 01:11 PM |
Linear Mode
