BENT SHIFT SHAFT INTERMEDIATE Mercruiser

tomdcat · #1 08-02-2006, 09:31 PM

I bent the shift shaft intermediate on my 1989 mercruiser alpha one drive while putting the outdrive back on.

I found a new part but I am afraid I will need to tear into the outdrive to replace.

Anyone have any experience with this ?

Is it difficuilt to replace this intermediate shaft?

It's made from brass

gonzo · #2 08-08-2006, 11:26 PM

It just pulls off. Make sure it aligns in the same spline as before.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
short shaft motor on long shaft boat	ohenry	Boat Design	0	03-21-2005 08:02 PM
bent wooden mast	Simon Monard	Sailboats	5	03-10-2005 03:08 PM
Bent Trim Piece	mikkyle	Fiberglass and Composite Boat Building	3	12-26-2004 08:15 PM
Bent Keel	lunker	Sailboats	9	08-26-2004 09:11 AM
Shift Problem	Logan1500	Powerboats	3	06-04-2004 09:23 PM