 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
07-04-2010, 12:38 PM
| |||
| |||
| 85 merc cruiser- impeller question Think my impeller is not working correctly. Motor overheated last night, no water working threw engine then it staller. My question is how to take the motor apart to get to the impeller? can anyone help?  |
|
#2
07-04-2010, 03:53 PM
| ||||
| ||||
| The impeller is in the lower unit. If the engine seized you have more serious problems. Impellers should be changed on a regular basis so you don't overheat and damage the engine.
__________________ Gonzo |
|
#4
07-05-2010, 02:16 AM
| ||||
| ||||
| Actually there are more. There is a nasty Allan screw that can only be reached after removal of the trim tab. No parts will fall out, just two O-rings will stick to one of the surfaces. There are several pump types, each with different impellers, so make sure you buy the right one.
__________________ Stupidity must be a virtue, whole industries, governments, even economies depend on it...... |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Merc Cruiser v-8 350 Thunderbolt Ignition | RandyO | Sterndrives | 6 | 06-22-2007 06:38 AM |
| Merc Cruiser Complete 140 Outdrive | DonW | Marketplace | 0 | 03-27-2007 06:51 PM |
| Merc Cruiser EFI to truck | k5chevyblazer | Powerboats | 3 | 01-22-2006 02:01 AM |
| impeller and thru hull question | accent33 | Powerboats | 4 | 06-02-2005 10:27 PM |
| Impeller Design Question | Design Engineer | Boat Design | 6 | 06-18-2004 06:13 AM |
Linear Mode
