 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
04-23-2009, 10:37 AM
| |||
| |||
| 1975 OMC Power Tilt mounting question Hi all: I am installing a pre-1976 power tilt/trim unit on a 1975 Johnson 115. This unit has a bracket/plate that mounts to the motor's midsection. There are six holes, the lower four are threaded and the top two are not. I have determined the lower four holes are threaded for 3/8-16 bolts and attaching the plate is fairly obvious for these. The question is what about the to two holes that are not threaded; is there some special part I need to secure the plate at the top? Thanks  |
|
#2
05-17-2009, 09:51 AM
| |||
| |||
| As I remember it they were always tapped.
__________________ Boat builders are not necessarily Boat designers who are not necessarily Engineers who are not builders who are not designers..... |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Tilt/Trim any OMC engineers out there? | Risejugger | Outboards | 0 | 04-18-2008 04:06 PM |
| 1999 Johnson 50Hp Power tilt/trim? | H20fwler | Outboards | 4 | 11-20-2007 07:18 PM |
| Another SBC OMC Question (Circa 1980) | Galaxie_406 | Sterndrives | 10 | 03-28-2007 11:16 AM |
| OMC / SBC Engine Electronics Question | Galaxie_406 | Gas Engines | 0 | 03-23-2007 11:58 PM |
| OMC Tilt | kahuna | Sterndrives | 1 | 09-20-2006 06:47 PM |
Linear Mode
