 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
12-30-2006, 11:29 PM
| |||
| |||
| Rebuild on a 1962 40 Hp Evinrude I just ordered a rebuild kit for my 1962 Evinrude 40 hp and began disassembling my engine. I beleive the impeller is ruined causing the engine to overheat. Anyways my I got the lower unit bolts unscrewed but cannot figure out how to disconnect the upper and lower unit? I can see the water tubes and driveshaft but cannot figure out how to disconnect them. Any help would be appreciated as to how to take it apart and replace the impeller! Thankyou  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1962 75hp Johnson Electramatic | GJF237 | Outboards | 2 | 01-11-2007 06:01 PM |
| Through hull's...... on a rebuild. | Roly | Wooden Boat Building and Restoration | 1 | 04-30-2006 02:24 PM |
| 1962 Jefferies Sportfisher 26' restore | davediemer | Fiberglass and Composite Boat Building | 2 | 03-04-2006 10:29 AM |
| 1962 Jefferies Sportfisher 26' restore | davediemer | Wooden Boat Building and Restoration | 0 | 02-25-2006 12:35 PM |
| Help with rebuild | PsyWarrior | Boatbuilding | 0 | 09-06-2002 10:14 AM |
Linear Mode
