 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
03-29-2008, 04:53 AM
| |||
| |||
| 1975 70hp Johnson Damn fine old OMC. But I don't deserve her. In a hurry to go fishing and ran over a rock.  Moral: Go to work instead!Anyhow,its done and I have replaced the prop, but the ride guide steering is only good for circles! The shaft going thru the o/b mount bracket appears bent. I straightened the tie rod. Can the cable end rod be straightened? or is there a cheap 'n cheerful remedy? Ride guide are no longer I believe? Any advice to get fishing appreciated!  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I Need Transom Clamps for 70hp Mercury 1979 serial No. 913920 Any idea's ? | IanMac | Outboards | 1 | 05-07-2007 10:30 PM |
| Trim unit wiring on a 1975 Johnson 115 | ZukiJon | Outboards | 1 | 01-07-2007 02:16 PM |
| 1975 SILVERTON 33 - Known Challenges? | BJB | Boat Design | 3 | 07-07-2006 08:06 PM |
| 1975 Kingfisher Transom & Stringer Repair | Kingfisher | Fiberglass and Composite Boat Building | 4 | 05-28-2005 10:17 PM |
| Help with my 1975 Renken 19' | jimgavula | Boatbuilding | 5 | 08-22-2004 01:48 PM |
Linear Mode
