| ||||
|
#1
| |||
| |||
| 1986 Four winns 190 horizon lights I have a 1986. Four winns 190 horizon. The problem is that once ithe motor is running. I cut on the lights and the motor and everything shuts down. Also the the mph, temp and some of the other meters don't work. If someone can help me I appriciate it. Thanks. |
|
#2
| |||
| |||
| Sounds like there is at least one short circuit. Trace the system with a multimeter and replace any bad wiring or connections. Your gauges may not work due to a short to ground, or due to corroded plugs/connections. Tim B.
__________________ Open Source Marine Charting - openpilot.sourceforge.net Open Source Vessel Dynamics opendynamics.engineering.selfip.org |
|
#3
| |||
| |||
| This happened to a friend of mine with a ski boat. In his case the gauges and switches fed from the engine harness. There was a bad connection or wire in the battery positive coming up to the panel from the engine. Due to the poor connection it could carry very little current. Turn anything on while the engine was running and in effect you would ground out the ignition and shut the engine down. If your wiring is configured the same way you need to be looking for loose connections, bad pin connector, bad ignition switch or broken wire(s) somewhere in the engine harness. |
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1986 four winns 190 horizon tying to start | coolmethirteen | Open Discussion: All Things Boats & Boating | 1 | 06-20-2010 07:44 PM |
| 1986 four winns boat with murc will not start | coolmethirteen | OnBoard Electronics & Controls | 6 | 06-02-2010 08:59 PM |
| Four Winns 240 Horizon hull design - porposing | DaleG | Powerboats | 2 | 12-12-2007 07:35 PM |
| Engine stalling in Four Winns Horizon RX 4.3L | tertel | Sterndrives | 8 | 06-08-2007 09:47 PM |
| Glastron GX 205 VS Four Winns Horizon 200 | D.Leinbach | Powerboats | 0 | 03-09-2004 03:35 PM |