 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
09-13-2006, 11:57 PM
| |||
| |||
| Good aluminum fab shop in Seattle area? I would like to find someone to perform some modifications on a 25' plate aluminum workboat that I own and was wondering if any of the NW folks on this board could recommend anyone? Or perhaps a mobile operator that would do the work at my shop? Thanks!  |
|
#2
09-22-2006, 06:24 AM
| |||
| |||
| Throw a rock in the air with your eyes closed and it will land in a good aluminum boatbuilder's shop. Seriously though, go by Kwichak, near the Fremont bridge and ask them, or ask at Elliott Bay Design Group on Shilshole nearthe Salmon Bay Cafe (www.ebdg.com). |
|
#3
09-22-2006, 12:26 PM
| ||||
| ||||
| Port Townsend Damn, I went down into the shop today and had to get a snow shovel for all the rocks on the floor...now I know why. I used to work at Kvichak, SafeBoats, Lee Shore and Townsend Bay. Now I have a fab shop here in P.T. I'm an economical choice for boats under 50'. jay_the_boatmaker@hotmail.com 360.379.4887 |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for good books on aluminum hull construction | stonebreaker | Metal Boat Building | 5 | 06-10-2006 04:23 PM |
| Replacement rudder for Alberg 35 - design and fab considerations | captain_willard | Boat Design | 3 | 02-06-2006 04:34 AM |
| Metal Fab and fishing... | CMP | Boatbuilding | 0 | 04-08-2004 03:34 PM |
| sail area to lateral area ratios | Ian | Boat Design | 5 | 04-07-2004 06:39 PM |
| Shop Practice | Lew Morris | Materials | 3 | 03-18-2003 12:58 AM |
Linear Mode
