 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#16
08-03-2010, 08:02 AM
| |||
| |||
| if a band saw is used i'd attach a square piece of metel at the end to keep it oriented and get a wood board to use as a table clamped to the saw table with guides to keep the tube centered and use a couple of dead men for the cut end. a stick of cutting wax will pay for itself http://www.nolansupply.com/bysubcate...se&specs=False  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PVC Pipe Canoe | camping nut | Boatbuilding | 19 | 09-22-2008 12:42 PM |
| fiberglassing PVC pipe?? | georgiahemi | Boat Design | 5 | 10-05-2007 06:05 AM |
| Pipe insulation----------possible floatation? | djwkd | Materials | 5 | 09-30-2006 05:29 PM |
| Pipe/tube bender | Dallas_B_ | Open Discussion: All Things Boats & Boating | 2 | 08-26-2005 07:05 PM |
| Pipe Rudder | Bob Smalser | Boatbuilding | 3 | 02-18-2005 02:01 AM |
Linear Mode
