 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
07-19-2007, 05:53 PM
| |||
| |||
| wanted: a source for 1.25" stainless rail fittings I've been unable to locate a source for 1.25" stainless steel rail fittings, the type used to assemble grab rails by using pre-fabricated components. I find many sources for 1" and smaller but nothing of greater diameter. If you happen to know where I might find a retailer I would appreciate the contact information. thank you.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wanted: 21cc to 23cc "Cat" molds | Agaponi | Boat Molds | 0 | 06-17-2007 09:25 PM |
| wanted: 5052 aluminum sheet .25" | pabble | Marketplace | 0 | 06-14-2007 10:59 AM |
| Info wanted on "Composite/fake timber" | kit | Materials | 0 | 12-27-2006 04:45 PM |
| Flexible "fiberglass" wanted | asathor | Materials | 4 | 04-04-2005 01:03 AM |
| Drawing for Rhino of "Boat Racing Chair" and "Machine Gun" | Vibtor | Software | 0 | 10-02-2004 03:03 PM |
Linear Mode
