 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
11-05-2003, 12:57 AM
| |||
| |||
| mold materials? I am going to carve an approxiamtely 6ft long hull out of foam for a mold, any suggestions on what kind of foam to use (makers) and where I can get it?  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| using existing hull as mold? | Rippin Lips | Boat Molds | 25 | 02-22-2006 03:36 PM |
| injection aided mold release | JV_Comp | Fiberglass and Composite Boat Building | 6 | 01-16-2006 07:41 PM |
| Direct female mold construction... | Brant Williams | Boat Design | 5 | 02-20-2005 07:19 PM |
| Lifeboat mold wanted | Antonie Bogert | Boat Molds | 3 | 01-19-2005 02:22 PM |
| mold materials? | kapnD | Materials | 5 | 11-15-2003 04:34 PM |
Linear Mode
