Transom Clamp Supplier

Jeffrey · #1 03-09-2006, 08:22 PM

I'm looking for a US supplier of transom clamps used for compressing the core material when building up the transom.
Thanks in advance.
Jeff

gonzo · #2 03-09-2006, 09:42 PM

Are you using plywood core?

COLE · #3 03-09-2006, 10:30 PM

I have aluminum ones cant even remember where I got them, But The best ones I have we made using some 2x3 light steel and making a reach we needed and put a (T) in the middle with 4 screw points at each side 2 up the center and 2 on the end of the (T) I only use 3 clamps and have The force of 12 That is the best I have found is my own. and the material cost is quite cheap takes a half day to make them. JC

Jeffrey · #4 03-10-2006, 04:12 PM

Gonzo,

I use 26# blue water Coosa.

Jeffrey · #5 03-10-2006, 04:14 PM

Cole,

I'm not sure I understand your explanation but I have a good idea of how to make some, I just wanted to get some prices first.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gelcoat Supplier?	Jaker	Materials	3	03-15-2006 04:10 PM
US supplier for Coremat®	mrbaseballny	Fiberglass and Composite Boat Building	2	07-19-2005 01:41 PM
Lumber Supplier	medphys3	Materials	2	07-11-2005 03:03 PM
Looking for a Responsible Gelcoat Supplier	turnershells	Materials	6	12-07-2004 09:26 AM
Electrical Supplier in CA.	GordMay	Materials	3	11-24-2003 04:44 PM