 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
07-28-2006, 12:23 PM
| |||
| |||
| Strut And Shaftlog Question I Am Reinstalling My Strut And Shaft Log On My 23.3 Formula. What Is The Best Sealant For These Two Parts To Seal Them To The Hull Permantely To Prevent Water Intrusion? Also Is A Laser Best Used To Align These Two Together? Thanks Dave In Fort Lauderdale  |
|
#2
07-28-2006, 12:33 PM
| |||
| |||
| We used MarineTex epoxy I don't know what else is out there that would be useable, but the shop where I worked used MarineTex epoxy. I'm not sure what the best way to align the strut is, but do that one first. Then align the the shaft to the trans/v-drive using the shaft itself, and allowing for a little bit of droop over the length of the shaft. After those are done, use the installed shaft to align the shaft log and packing gland. |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stainless V Strut vs Bronze V Strut | jameshogan | Materials | 7 | 05-17-2009 07:03 PM |
| Strut alloy | ABoatGuy | Propulsion | 2 | 01-09-2006 08:44 PM |
| Strut Calculations | Timm | Propulsion | 12 | 10-10-2005 01:03 PM |
| strut suppliers? | drs3317 | Propulsion | 1 | 08-16-2005 01:17 PM |
| Steel to use in a keel strut casting | budner1 | Boat Design | 3 | 05-03-2005 11:10 AM |
Linear Mode
