 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
05-26-2007, 10:50 AM
| |||
| |||
| Rudder Erosion - Common causes? Assuming that electrolysis is ruled out, what would be the most common causes of leading edge rudder erosion in a typical inboard engine installation. In this case, both port/stbd rudders are offset a few inches outboard from shaft centerline and have significant clearance aft of propeller. Any comments / suggestions would be most appreciated.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I am asking common questions about building a boat | rageplayermp1 | Powerboats | 4 | 11-26-2006 11:25 PM |
| Common Sense of Yacht Design | Robert Gainer | Boat Design | 1 | 08-11-2006 08:30 PM |
| Outboard rudder vs. inboard rudder | designdreamin | Boat Design | 0 | 06-27-2006 11:05 PM |
| Rudder Angle And Effective Size Of Rudder... | saildog | Sailboats | 5 | 03-06-2006 04:34 PM |
| New Rudder verses Old Rudder | Cliff Ruckstuhl | Sailboats | 0 | 03-06-2004 04:36 PM |
Linear Mode
