 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
01-09-2006, 01:49 PM
| |||
| |||
| Spindrift design mods I have the plans for the spindrift 11N. I am looking to reduce the weight of the dingy, as I want the halves as easy to get up on board as possible. I also want to try a larger carbon fiber/vacuum bagging project, so i'm looking to merge the 2. Here's my idea: construct a hull form of the spindrift out of cheap door skin wood, then thermoform Structural Closed-Cell Foam over it, then glass it in Carbon/Kevlar twill. Anyone see any problems with this?  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| College for Naval Architecture | Archive | Education | 15 | 04-07-2008 12:42 PM |
| Master in yacht design | ambas | Education | 26 | 05-11-2006 01:47 AM |
| SNAME Small Craft Papers CD | sorenfdk | Boat Design | 6 | 12-29-2005 03:33 PM |
| Looking for the right path to design and build | ben_morel | Education | 44 | 11-24-2005 03:51 PM |
Linear Mode
