 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
09-19-2005, 01:13 PM
| |||
| |||
| Mold JPEG.. is this any good? Would someone care to comment on this image? The pattern has an issue. A mold I looked at recently has a few spots like this. Not sure how bad it is to fix? If its usable or not or ?? Thanks James Hogan  |
|
#2
09-20-2005, 07:47 PM
| ||||
| ||||
| Oh, damage can be repaired... just a matter of $$ and patience. That texture will be hard to match. But yes, the damage can be fixed, if you want to put in the effort.
__________________ - Matt Marsh - Marsh Design (small craft blog and designs) |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a Mold and Laminating Schedule | Cpt Albert | Fiberglass and Composite Boat Building | 6 | 05-26-2006 04:57 PM |
| injection aided mold release | JV_Comp | Fiberglass and Composite Boat Building | 6 | 01-16-2006 07:41 PM |
| Direct female mold construction... | Brant Williams | Boat Design | 5 | 02-20-2005 07:19 PM |
| Design to fit a mold?? | Bill Staff | Boat Design | 2 | 12-06-2004 03:10 PM |
| Retooling molds? | Guest | Fiberglass and Composite Boat Building | 4 | 07-12-2004 05:16 PM |
Linear Mode
