 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
10-13-2006, 07:34 AM
| |||
| |||
| fiberglass and cast(gypsum) panel? Sorry on my bad English grammar-Thanks! I want to bulid fiberglass track sandwich with polyuretan foam thickness 2 cm. Track will be 6 meter length and 90 cm depth. Track will be located on flat hard stand and people will walk over track. My question is, how much layer of fiberglass I must put over foam? Track must be hard enough to hold two or three pople. Note: I want to use less material as possible Last edited by zeljkomrsic : 10-17-2006 at 07:17 AM.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cast aluminium boat | Ari | Metal Boat Building | 7 | 10-02-2006 11:35 PM |
| Plexi-- Cast or Extruded | nassaw | Materials | 5 | 10-14-2005 07:06 AM |
| Sea-Cast... | tonyg1178 | Fiberglass and Composite Boat Building | 5 | 09-13-2005 10:03 PM |
| finishing cast iron | tranmkp | Materials | 2 | 02-09-2005 06:03 AM |
| fiberglass panel boat building | rongo | Boatbuilding | 12 | 07-15-2004 02:49 PM |
Linear Mode
