 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#16
06-28-2007, 08:16 PM
| ||||
| ||||
| I've looked at some different tank configurations and don't care for lack of access. If the tank needed any kind of service it would be a pain. I did find these pics that show the 22oz. I will try harder to make sure the substrate is better prepared ie flatter, better radius's. This 22 oz triaxial e-glass and the warp bundles are very large bundles. One area looks like it has air but it's the fairing mix. Last edited by Bullseye : 07-01-2007 at 03:41 PM.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can Fiberglass,Carbon or Kevlar be used w/Mahogany in cold molding? | cudashark | Boatbuilding | 8 | 08-06-2006 08:35 AM |
| prepeg carbon/kevlar | the_sphincter | Materials | 1 | 11-22-2005 04:47 PM |
| e-glass vs. aramid/kevlar vs. carbon | JEM | Materials | 12 | 06-12-2005 03:19 PM |
| Braided Kevlar/carbon sleeve application | snowman_fs | Fiberglass and Composite Boat Building | 4 | 04-02-2005 07:02 AM |
| 9 oz kevlar | Materials | 3 | 12-12-2002 03:55 PM | |
Linear Mode
