Prosurf 3.0

[Luis M Pinho]

Hi all,

I have a full license Prosurf 3.0 for a couple of years. I first intended to use it as a nurbs modeler, but later bought Rhino 4.0 for that purpose, but I still use Prosurf 3.0 for some tasks, such as line fairing, NACA foils generation, txt output of geometry and so on.

Recently I bougth a new computer and wanted to install it there, but you have to get a new key each time you install it.

I wrote to the email address on the web site and got no reply so far.

Any one out there that had a similar problem and could help?

Thanks in advance,
Luis

[CGN]

sometimes is hard to get in contact Stephen but no doubt he is there just keep trying.

I understand is frustrating but he'll will answer, there has been some other comments that it takes some time to hear from him, i went trough the same but i had my key and is working just fine

cheers

[Luis M Pinho]

Hi,

Steve got back to me and all is fine now!

Thank you very much for your reply!

Best Regards,

Luis