 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
07-06-2005, 03:21 PM
| |||
| |||
| NURBS surface Hi guys, Is it possible with Matlab to build a surface based on 2 NURBS? I've used a CAD package for that, but the script runs for a while. I need to extract the points on the surface (conducted by 2, 3 or even 4 NURBS as bounds, to form a closed profile) equally spaced on the both main axes. In CAD packages, one can just sweep a NURBS along the other and get the surface, which is going to be intersected by 2 sets of orthogonal planes to each NURBS to get some certain x-y grid points. I'd appreciate any help. Suhoi  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| efficiency of surface drives and surface piercing propellers | David Knight | Powerboats | 7 | 09-24-2009 05:10 PM |
| iges trimmed surface problem in maxsurf | hasicktear | Software | 16 | 02-13-2006 12:25 PM |
| Wetted surface area - approximate formulas | Mike D | Boat Design | 11 | 08-25-2005 12:00 PM |
| Building a heat exchanger into the hull | djackson99 | Powerboats | 42 | 03-21-2005 03:15 PM |
| surface trimming in Maxsurf, NavalDesigner and or Autoship | innomare | Software | 5 | 02-14-2005 08:16 PM |
Linear Mode
