Maxsurf stability enterprise

Discussion in 'Software' started by NITHIN BABU, Feb 3, 2016.

  1. NITHIN BABU
    Joined: Mar 2015
    Posts: 16
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: India

    NITHIN BABU Junior Member

    Hi there!
    I am facing a problem while trying to perform upright hydrostatics and equilibrium on my catamaran. The error message reads "Trim value exceeds -45...", But i get hydrostatics values of same model in maxsurf modeler.

    Am I overlooking something?

    Thanks,
    Nithin
     
  2. vkstratis
    Joined: Feb 2015
    Posts: 75
    Likes: 9, Points: 8, Legacy Rep: 14
    Location: Athens, Greece

    vkstratis Naval Architect

    Hi,

    check your LCG location at the loadcase that you use for equilibrium analysis. I suppose it is at its default value (zero) causing your error.
     
  3. devudegoa
    Joined: Feb 2016
    Posts: 14
    Likes: 1, Points: 0, Legacy Rep: 36
    Location: Visakhapatnam, India

    devudegoa Junior Member

    As "vkstratis" mentioned, most likely the LCG value in the loadcase is the reason for the error. Please check if correcting that value solves the issue.
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.