 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
08-03-2004, 04:44 AM
| |||
| |||
| hull surface at rhino hello, I have a problem I have the frames of the hull and I wish to form the hull surface. How can I do that? thanks  |
|
#2
08-03-2004, 10:32 AM
| |||
| |||
| go to: http://www.rhino3d.com/tutorials.htm look for: Fairing Curves and Surfaces that is just for a quick start, and then, you can follow most of the excellent posted comments, here in the forum. |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How about boat design definitions | JonathanCole | Boat Design | 55 | 01-24-2010 04:48 PM |
| Jet Drive | Jet Drives | 15 | 12-18-2006 09:51 AM | |
| iges trimmed surface problem in maxsurf | hasicktear | Software | 16 | 02-13-2006 11:25 AM |
| Stepped Hulls | Ryon Macey | Powerboats | 53 | 08-01-2004 10:44 AM |
| Wetted surface area II: Cat hulls or Monos? | Mike D | Boat Design | 1 | 09-25-2002 11:26 PM |
Linear Mode
