 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
11-11-2007, 09:36 PM
| ||||
| ||||
| CONTROL POINTS in Rhino Marine... Hello... Quick question - why do I lose the hard edges of the chine developed in Rhino Marine 'planing hull wizard' when I add control points to the hull... Is there a way of doing same and preserving the 'edges'... Thanks in advance... SH.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rhino - Triangulate 3d points? | AlexDim | Software | 11 | 07-04-2007 07:47 AM |
| Modeling for Marine Industry Rhino CD? | snow 57 | Boat Design | 1 | 05-30-2007 06:47 AM |
| CG in Rhino marine | ct marine nz | Software | 3 | 02-09-2007 05:59 AM |
| Moving multiple control points in FreeShip | SeaSpark | Software | 4 | 06-15-2006 06:02 AM |
| Fitting a Curve to Offsets Points in Rhino | CET | Software | 6 | 01-04-2006 08:31 AM |
Linear Mode
