Autoship_Autostructure

[ringoo83]

Hi all;

I don't know if the designers are familiar with Autostructure , but it's one of Autoship programs, used for structural designing and combined with autoCAD;

I wonder if some one can help me with the following problem I face: whenever I use Automatic Placement Dialog, I can't creat brackets I tried many ways and I failed, the following screen shots are self explantory.


Pic 1 shows 2 corrupted parts (status -100) resulted from old trials to create brackets.

Pic 2 shows the steps I followed to create a bracket between stiffener end – panel, the type of brackets is shown down.

Pics 4 & 5 show 2 error messages.

Pic 6 shows 2 parts (welds) resulted from the creating of the bracket which was not created itself.

Pics 7 & 8: I closed Autostructure and re-started it back, I got this new error message which tells that the bracket was corrupted even I didn’t find this bracket before or after restarting (Not created, or may be created but not shown)


I couldn’t create any bracket by Autostructur release 3.1.0

Any response will be highly appriciated

Thanks in advance