 |  |
| Boat Design Forums | Boat Design Directory | Boat Design Gallery | Boat Design Book Store | Thanks to Our Site Sponsors |
| ||||
|
#1
07-12-2005, 09:09 PM
| |||
| |||
| 8'9" Sailing dinghy/Tender Mold I came across this set of molds in my travels for a small 8'9" Dinghy/Tender, with floatation built in and a swing center board option. Had plans to build one but have since turned my attention to aluminum. The Dinghy was originally built by the late Don Pearson of Tampa FL. and has quite a following in that area. The molds need cleaning up and I feel they are going to waste, so if anyone out there is interested I will sell them for $400 or make me an offer. 352-551-6236. Patrick.  |
 |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Foiler Design | tspeer | Sailboats | 1031 | 12-17-2010 02:38 AM |
| injection aided mold release | JV_Comp | Fiberglass and Composite Boat Building | 6 | 01-16-2006 08:41 PM |
| Direct female mold construction... | Brant Williams | Boat Design | 5 | 02-20-2005 08:19 PM |
| Lifeboat mold wanted | Antonie Bogert | Boat Molds | 3 | 01-19-2005 03:22 PM |
| Design to fit a mold?? | Bill Staff | Boat Design | 2 | 12-06-2004 04:10 PM |
Linear Mode
